Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Description
Standard Andis Blade
1/8" Blade Attachment
1/4" Blade Attachment
3/8" Blade Attachment
1/2" Blade Attachment
USER MAINTENANCE
The internal mechanism of your motor clipper has been permanently
lubricated by the factory. Other than the recommended maintenance
described in this manual, no other maintenance should be performed,
except by Andis Company, or an Andis authorized service station. To contact
Andis directly, please call our Customer Support Team at 1-800-558-9441 or
email us at support@andisco.com.
REMOVING BLADE SET
To remove blade set, first make sure your clipper is switched OFF and
UNPLUGGED. Push down on blade, then gently pull the blade forward
(Figure C), and slide it off the blade hinge. If your blade hinge should snap
closed and is flush with the clipper, use a small standard screwdriver to pry
the tongue of the hinge out (Figure D). NOTE: Hair may accumulate in the
front cavity of the housing under the blade. If this happens, you can clean
out the hair by brushing out the cavity with a small brush or an old
toothbrush while the blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge
of the clipper (Figure E) and with the clipper turned ON, push the blade
towards the clipper to lock into position.
4
CLIPPING GUIDE
Clipping Direction
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
With hair grain
Against hair grain
Approximate Length of Cut
Fine
1/16"
to
1/32"
to
1/4"
to
1/8"
to
3/8"
to
1/4"
to
1/2"
to
3/8"
to
5/8"
to
1/2"
to
Coarse
3/16"
1/8"
3/8"
1/4"
1/2"
3/8"
5/8"
1/2"
7/8"
5/8"
Publicidad
