Publicidad
Idiomas disponibles
Idiomas disponibles
Special Safety Instructions
The water level must be between the MAX. and MIN. marks!
WARNING: Do not exceed the MAX mark when filling, otherwise the water may boil over and
cause burns!
Use only cold water when filling.
Use the appliance only on a level work surface.
Always ensure that the lid is tightly closed.
Please do not open the lid when the water is boiling.
Do not move the device and do not touch it when it is working.
Only use the kettle with the accompanying base.
Switch the machine off before removing it from the base.
The base and exterior of the machine must not become wet.
Children and Frail Individuals
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
In order to ensure your children's safety, please keep all packaging (plastic bags, boxes, polystyrene etc.)
out of their reach.
WARNING!
Caution! Do not allow small children to play with the foil as there is a danger of suffocation!
In order to protect children or frail individuals from the hazards of electrical equipment, please ensure
that this device is only used under supervision. This device is not a toy. Do not allow small children to
play with it.
Children should be supervised to ensure that they do not play with the appliance.
Instructions
Preparation
Before using for the first time, boil fresh water at least three times in the appliance. Use only water without
any additives or ingredients.
Electrical connection
Check whether the electrical voltage that you intend to use is the same as that of the machine. Details are to be
found on the label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200W. With this connected load a separate supply
line protected by a 16A household circuit breaker is recommended.
CAUTION: OVERLOAD:
-
If you use extension leads, these should have a cable cross‐section of at least 1.5 mm2.
-
Do not use any multiple sockets, as this device is too powerful.
2
English
Publicidad
