Installation
BASE INSTALLATION
- Remove the utility sink (D) and place it on a soft, protective
surface .
- Turn the cabinet (A) upside down onto the protective surface .
- Attach the cabinet base (C) onto its proper location . Using the
supplied base screws (BB), attach the base to the cabinet .
- Attach leveling feet (G) to the base .
- Gently rotate the cabinet (A) right side up .
- Place a carpenter's level on top of the cabinet, then adjust each
leveling foot until the cabinet is level .
DOOR HANDLE INSTALLATION
- Insert the door handle screws (AA) into the pre-drilled holes on
each door .
- Attach the door handle (H) and hand tighten the door handle
screws (AA) .
- Repeat on other door .
HOW TO CHANGE THE DOOR PANEL
NOTE: The door panel is reversible showing either white or
black, follow the instructions below to change it .
- Loosen the screws in the tabs . Turn the tabs so they are no
longer covering the panel . Remove the panel .
- Place the new panel in place . Turn the tabs so they hold the
panel in place . Tighten the screws . Do not over tighten .
QL106
CAUTION:
Do not place side load onto feet when righting
the cabinet .
C
BB
G
A
1
2
6
H
AA
3
4