Profi Care PC-HT 3082 Manual De Instrucciones página 26

Notes for Use
Accessories
• If you wish to dry individual areas of your hair specifically,
attach the magnetic styling nozzle. That will concentrate
the air flow.
• Allow the appliance to cool down before removing the
nozzle. You may speed up the process by using the
button to enable the COOL SHOT function for about
30 seconds during use. You may then simply remove
the nozzle.
Ionizing Function – Reduction of Static in Hair
The appliance is also fitted with an ionizer which gives off
negative ions with the air flow when switching on. This pro-
cess supports safe, gentle drying of hair and also promotes
a better hair structure, maximizes hair volume, provides for
a silky finish and also reduces static in the hair.
This process is particularly gentle on stressed hair.
Commissioning
Unwind the mains cable completely.
Electrical Connection
1. Before inserting the plug into the socket, make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
2. Connect the appliance to a properly installed earthed
socket.
WARNING:
• Before cleaning remove the mains lead from the socked.
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
26
PC-HT3082_IM
Slide the switch on the handle to the desired heat / blower
setting:
Position = Off
Position = Moderate airflow and low temperature
Position = Strong airflow and medium temperature
Position = Strong air flow and high temperature
NOTE:
During operation, the rear part of the appliance is illumi-
nated by LEDs.
COOL SHOT (Cold Air)
With this switch you can stop the heating process.
Press the button to enable the COOL SHOT function. Press
it again to disable the function.
NOTE:
For technical reasons, the enabled function cannot be
displayed. Therefore, you need to check during operation
whether the function is enabled.
Switch-Off
Set the switch to after use. Disconnect the mains plug
from the socket.
• Leave the appliance to cool down before putting it away!
• Hang the appliance up by the suspension eye.
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the appliance, as over
time this may result in the cable breaking.
• Check the mains cable regularly for damage.
Cleaning
Use
Storage
13.05.20