Publicidad
Idiomas disponibles
Idiomas disponibles
Before using the tool ensure the work area is clean and well lit.
Before switching on set the speed dial to the slowest setting.
Best performance is achieved by using the correct speed and not high pressure. As a
guide use slow speeds for the larger tools, and high speeds for the small tools. Use slow
speeds on wood and plastics, or when using polishing and brushing accessories.
For milling or engraving hold the tool like a pen, and keep the ventilation slots clear.
For heavier work hold the tool like a hammer.
For cutting disks hold the tool in both hands and use high speeds. This accessory is
brittle and should only be used for straight cuts. Do not sand or curved holes.
If the tool slows down or over-heats you may be applying too much pressure.
The tool is most effective with clean sharp tools. If more pressure is needed try
cleaning or replacing the accessory.
Some accessories are brittle. Use the tools speed and not pressure to do the work.
It is recommended it is run for 15 minutes of normal use. The tools should then be
allowed to cool for 30 minutes. Heavy use may give less than 15 minutes continuous use.
The mini grinder has a variable speed control mechanism designed to allow the
operator control and adjustment of speed. The speed can be increased or decreased
by the rotation of Speed selector.
To lock on the mini grinder, push the switch and squeeze the lock-on button laterally
along the locked direction.
To turn off the mini grinder, push the lock-on button laterally along the unlocked
direction.
8、TECHNICAL DATA
Power supply
Power input
Rated Speed
Collet capacity(max)：
Grinding disc (max):
Mandrel length(max):
9、NOISE
L
(Sound pressure level):
PA
L
(Sound power level):
WA
Vibration level a
:
h
Note:
- that the declared vibration total value has been measured in accordance with a standard
test method and may be used for comparing one tool with another;
- that the declared vibration total value may also be used in a preliminary assessment of
exposure.
Warning:
- that the vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used;
220-240V~50Hz
130W
10000-35000/min
Ø3.2mm
Ø35mm
45mm
72 dB(A)
K=3 dB
83dB(A)
K=3 dB
1.42m/s
K=1.5m/s
2
91
2
Publicidad
