OVE SYDNEY SIDE PANEL 32 Instrucciones De Montaje página 10

1. Insert the fixed panel's bottom seal strip (I) at the base of the fixed glass panel (A), 40mm (1 9/16in) from the
panel's edge.
2. Place the sliding door guide (E) on the base. Ensure the distance that is shown in the image (2).
3. Mark the positions of holes of the sliding door guide (E) with a pencil, and drill pilot holes with a ø3mm (1/8in) drill
bit.
4. Fix the sliding door guide (E) with the screw (BB) and cap (KK). Ensure the plastic gasket in the guide is in place as
it protects the fixed glass panel
5-6. Place the fixed glass panel (A) into the wall track (B) and the sliding door guide (E).
Note: The wall track (B) allows you to adjust the position of the fixed glass panel (A). Adjusting the depth and/
or giving the fixed glass panel a slight angle allows for precise alignment with the door.
7-8. Once all adjustments have been made, drill the fixed panel (A) with Φ 3mm (1/8in) in 3 places, secure the wall
track (B) using screws (AA), fittings and caps (FF).
5
B
A
FIXED PANEL INSTALLATION
6
A
E
1
A
I
3
Φ 3mm
1/8in
7
Φ3mm
A
1/8in
10
2
E
565mm
22 1/4in
4
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
8
AA
A
KK
BB
E
FF