Adjustments; Miter Scale Pointer Adjustment - skilsaw SPT62MTC Instrucciones De Funcionamiento Y Seguridad

1609B00427 eng.qxp_SPT62MTC 5/12/15 1:53 PM Page 12
assembly, adjustment or repair to avoid possible
injury.
NOTE: Your saw was completely adjusted at the
factory. However, during shipment, slight misalign-
ment may have occurred. Check the following set-
tings and adjust if necessary prior to using this saw.
Miter Scale Pointer Adjustment (Fig. 6)
1. Lock the saw head assembly in the DOWN po-
sition with the head assembly lock pin 19.
2. Lift the quick release lever 23 and pull the work-
piece clamp 15 away from the fence 21.
3. Loosen the miter lock lever 16.
FIG. 6
17C

Adjustments

Disconnect plug from power
source before performing any
17B
17A
16
4. Set the fence 21 to 0° position by placing the
combination square C between the blade 6 and
fence 21.
5. Lock the fence 21 in place by tightening the miter
lock lever 16.
6. Loosen the pointer adjust screw 17B that holds
the miter scale pointer 17A in place.
7. Position the pointer to align with the 0° line on
the miter scale 17C.
8. Tighten the pointer adjust screw 17B.
21
-12-
6
C