Hotpoint Ariston LST 216 Manual De Instrucciones página 15

Electrical connection
Before inserting the plug into the electrical socket, make
sure that:
• The socket is earthed and complies with current
regulations.
• The socket can withstand the maximum load of the
appliance, which is indicated on the data plate located
on the inside of the door (see chapter entitled Description
of the appliance).
• The power supply voltage falls within the values indicated
on the data plate on the inside of the door.
• The socket is compatible with the plug of the appliance.
If this is not the case, ask an authorised technician to
replace the plug (see Assistance) ; do not use extension
cables or multiple sockets.
Once the appliance has been installed, the power supply
cable and the electrical socket should be easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be re-
placed by the manufacturer or its Technical Assistance
Service in order to prevent all potential hazards. (See As-
sistance)
The Company shall not be held responsible for any
incidents that occur if these regulations are not observed.
ECODESIGN REGULATION
ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a nor-
mal soil level and is the most efficient in terms of energy and water consumption for this type of crockery. To reduce consumption
even further, only run the dishwasher when it is full.
Standby consumption: Left-on mode consumption: 3 W – Off mode consumption: 1,3 W
Consumption data table for the main cycles
Standard conditions
Energy consumption
(kWh/cycle)
1,30
INTENSIVE
NORMAL 1,05
*
Cycle data refers to the values recorded in a laboratory, in accordance with European standard EN 50242.
**
Data is obtained by recording values when the appliance is operational and loaded with user crockery.
*
Water consumption Duration
(l/cycle) (min/cycle)
14 150
14 115
*
Anti-condensation strip
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before
running the first wash cycle, completely fill the salt dispenser
with water and add only then approximately 1 kg of salt
(see chapter entitled Rinse aid and refined salt) . The water
may overflow: this is normal and is not a cause for concern.
Select the water hardness value (see chapter entitled Rinse
aid and refined salt) . - After the salt has been poured into
the machine, the LOW SALT indicator light
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.
Technical data
width 44.5 cm
Dimensions height 82 cm
depth 57 cm
Capacity 10 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
Water supply pressure
7,25 – 145 psi
Power supply voltage See appliance data plate
Total absorbed power See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/ EC (Waste Electrical
and Electronic Equipment WEEE)
**
User conditions
Energy consumption Water consumption
(kWh/cycle) (l/cycle)
1,15 14
0,95 13
EN
*
switches off.
Duration (min/
cycle)
140
110
15