Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before at-
tempting to assemble, operate, or install the product.
This light fixture requires 120-volts AC. All wiring must be
in accordance with the National Electrical Code (Canadian
Electrical Code in Canada). Some local electrical codes
require installation by a qualified electrician.
WARNING
• Turn power off at circuit breaker or fuse when
wiring fixture or replacing bulbs. Place tape over
circuit breaker switch and verify power is off at
the fixture.
CAUTION
• Do not cut any wires that have factory installed
wire connectors or remove the wire connectors.
PREPARATION
Before beginning installation of product, make sure all parts
are present. Compare parts with hardware contents list. If
any part is missing or damaged, do not attempt to assemble,
install, or operate the product.
Tools Required for Assembly (not included): Phillips and
flathead screwdrivers, pliers, wire strippers/cutters, multi-
meter, electrical tape, silicone sealant, safety glasses, work
gloves, and ladder
• For easy installation and to operate the light using Manual
mode, replace an existing light fixture operated by a wall
switch.
• Do not connect to dimmers or timers.
• For best performance, mount fixture about 6 feet (1.8 m)
above the ground.
Estimated Installation Time: 30 minutes
HARDWARE CONTENTS
Note: Illustrations may vary from actual unit.
C
3x – Wire Connectors
2x – Mounting
Bracket Screw
2
A
B
A - (1x) Mounting Bracket
B - (2x) Fixture Mounting
Screws
C - (2x) Decorative Nut
(This assembly is attached to
the rear of the lantern canopy .)
200254-03
Publicidad
