Publicidad
Idiomas disponibles
Idiomas disponibles
1. LIGHTING INSTRUCTION
A. The heater has three settings. Lighting and minimum heat (Pos.1); medium heat
(Pos.2) and maximum (Pos3)
B. Place the gas filled cylinder into the back of the heater.
C. Clip on the gas regulator to the gas cylinder.
D. Turn on the gas regulator.
2. LIGHTING
Press the control button for 10 seconds at the Position 1, at the same time press
the electronic igniter key to lit with thumb finger of left hand, Continue this pro-
cedure until pilot ignites, approximately after 20 seconds leave control button.
At this stage if the pilot is alight, If the pilot flame goes out please repeat this
procedure. and then turn the knob to Pos.2. to minimum power setting,
3. HEAT SETTINGS
To change from minimum to maximum gently press control button and turn it to
position 3.
To change from maximum to medium gently press control button and turn it to
position 2.
4. TURN OFF THE HEATER
Turn off heater at cylinder valve. NOTE: The heater can be turned off at the cyl-
inder valve ONLY. If the heater is not used for a period of time, disconnect the
regulator from the cylinder and replace any value protection plug or cover.
OPERATION GUIDE
Publicidad
