Publicidad
Idiomas disponibles
Idiomas disponibles
9. Position handset at front edge of tabletop in desired
position. Secure to tabletop using two handset screws
and drill with Phillips head drill bit. (See Figure 9)
NOTE: Screws are packaged with handset.
Figure 9
Handset
Screw
10. Flip table upright. Place "F" Allen head bolts into side
mounting plates on one rear lifting
(See Figure 10)
IMPORTANT! Do not
fully tighten. Leave
large portion of
threading to allow
for installation of
stringer.
PAGE 4 OF 42
ASSEMBLY CONTINUED
11. Place stringer between rear lifting columns, aligned
12. Place keyhole slots on
column.
F
13. Align opposite end of stringer with side mounting
Figure 10
with side mounting plates. Access hole in stringer
should face the back side of the workstation. Loosen
Allen head bolts on bottom of stringer to expand to
width of lifting columns. (See Figure 11)
Figure 11
end of stringer onto
previously installed
"F" Allen head bolt
threads.
Push stringer
down so bolts are in
smaller hole on slots.
Tighten "F" Allen head
bolts to secure.
(See Figure 12)
plate. Insert two "F" Allen head bolts through stringer
and into side mounting plate. Tighten "F" Allen Head
bolts to secure. (See Figures 13a-13b)
Figure 13a
Figure 12
Figure 13b
0323 IH-10268
Publicidad
