voestalpine bohler SABER 70 CHP Manual De Instrucciones página 39

Passing one of the warning limits causes a visual signal to appear
on the control panel.
Passing one of the alarm limits causes a visual signal to appear
on the control panel and the immediate blockage of the cutting
operations.
It is possible to set start and end of cutting filters to prevent error
signals during the striking and extinction of the arc (consult the
"Set up" section - Parameters 802-803-804).
3.10 Alarms screen
Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E01, E02 Temperature alarm
It is advisable not to switch off the equipment while the alarm
is on; the internal fan will thus keep operating and will help to
cool the overheated parts.
E10 Power module alarm
E13 Communication alarm
E16 Communication alarm (RI)
E19 System configuration alarm
E20 Memory fault alarm
E21 Data loss alarm
E40 System power supply alarm
E45 Air pressure alarm
E47 Nozzle retaining cap guard alarm
E49 Emergency switch alarm
E78 Active maintenance alarm
(Automation and robotics)
E99 General alarm
Guard limits code
E54 Current level exceeded (Alarm)
E62 Current level exceeded (Warning)
E55 Current level exceeded (Alarm)
E63 Current level exceeded (Warning)
E56 Voltage level exceeded (Alarm)
E64 Voltage level exceeded (Warning)
E57 Voltage level exceeded (Alarm)
E65 Voltage level exceeded (Warning)
E58 Gas pressure level exceeded
E66 Gas pressure level exceeded
E59 Gas pressure level exceeded
E67 Gas pressure level exceeded
E60 Speed limit exceeded
E68 Speed limit exceeded
(Alarm)
(Warning)
(Alarm)
(Warning)
(Alarm)
(Warning)
39