Craftmade Bellows IV BW414 Guia De Instalacion página 6

6. Fan Assembly.
Secure fan to wall bracket by inserting the
tube into the wall bracket. Then, tighten
the four set screws on the wall bracket
with the Allen wrench provided in one of
the hardware packs.
Slide canopy to wall bracket and tighten
set screws on canopy with the Allen
wrench.
7. Wall Control Wiring.
IN ORDER TO WIRE WALL CONTROL,
remove existing wall switch. Wire the WALL
CONTROL with wire connectors provided as
shown in diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire
connectors into outlet box.
WARNING: CONNECT WIRES IN THE
FOLLOWING ORDER:
Connect GREEN GROUND wire to GROUND
from house or directly to one of the screws
from the outlet box.
Connect BLACK/WHITE wire from wall
control to BLACK (hot) lead wire from house.
Connect BLACK wire from wall control to
BLACK load wire to fan.
Connect BLUE wire from wall control to
BLUE load wire to fan.
Attach wall control to electrical outlet/box
and secure with screws from original wall
switch. Attach front plate to wall control
using 2 screws provided in the wall control.
tube
outlet box
GREEN/BARE GROUND
BLACK
BLACK
(AC IN L from
breaker box)
BLUE
(blue load from fan)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
page 6
allen
wrench
set
screw
allen wrench
set screw
canopy
wall control
GREEN
BLACK (to motor)
BLACK w/ WHITE
STRIPE (AC IN L)
BLUE
(fan rotation)
wall bracket
plate