How To Tap A Keg Of Beer / Sankey Type Barrel; Install The Air Channels And Draft Towers - ASBER Slim Line ABBC/DD-24-36 Manual De Instrucciones

2.7.1 How to Tap a Keg of Beer / Sankey Type Barrel

1. Connect line from pressure source to tap
nipple (use clamp).
2. Using coupling washer connect beer line to
thread on probe. Holding flats on probe
with wrench tighten wing nut or hex nut on
beer hose.
3. Align tap with lugs in barrel, insert tap.
4. Turn tap body handle ¼ turn clock wise
until tight to secure tap to barrel. Turn on
pressure regulator.
Rotate wheel handle ¼ turn clock wise. Be
certain handle is turned as far as it will go to
stop. This will assure that the beer and gas
pots in the keg down tube will be fully opened.

Install the Air Channels and Draft Towers

2.8
This procedure describes how to install the air channel needed to provide cold air directly into the beer
towers.
Tools needed: Philips Screwdriver
Step 1
Locate the gaskets and bolts
included in with your Tower.
Place gasket over the pre-drilled
holes and place the 4 screws
thru the tower base. Align the
tower with screws and gasket to
the cabinet top as shown below
while dropping the beer line(s)
thru the top of the unit.
5
asberprofessional.com
Step 3
Identify the "WHITE
HOSE" which is found
inside of the equipment.
Step 2
Tighten the screws using the
nuts found in your tower box.
Step 4
Introduce the "WHITE
HOSE" which is found
inside of the equipment
into the tower's hole.
Be sure that the hose's
hook is correctly
attached into the tower
hole.
asberprofessional.com