Franke FDFPL 905 W XS Manual De Uso página 10

4. CONTROLS
Button Led
T1
-
All the Leds
flash 3
times.
T2 Fixed
T3 Fixed
The Led
correspondin
g to the
speed that
has been set
flashes once
every
second.
T4 Fixed
Flashes
twice a
second.
L
-
LIGHTING
• For replacement contact technical sup-
port ("To purchase contact technical
support").
10
Function
Turns the Motor off.
When the filters alarm is triggered, the alarm can be reset by pressing and
holding this button for approximately 5 seconds. These indications are only
visible when the motor is turned off.
When the procedure terminates, the indication shown previously turns off:
Led T2+Led T4 flash, indicating the need to wash the metal grease filters.
The alarm is triggered after the Hood has been in operation for 100
working hours.
Led T2+Led T3 flash, indicating the need to change the activated charcoal
filters, and to wash the metal grease filters. The alarm is triggered after the
Hood has been in operation for 200 working hours.
Turns the Motor on at Speed one.
Turns the Motor on at Speed two.
Turns the Delay Function on and off when pressed and held for 2 seconds.
Activates automatic switch-off (Motor+Lights) with a 30' delay. Suitable
to complete elimination of residual odours. Can be activated from any
position when the Intensive function is disabled, and is deactivated by
pressing the button or turning the motor off.
Turns the Motor on at Speed Three.
Turns the Intensive Function on and off when pressed and held for 2
seconds.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. It is disabled by
pressing the button or turning the motor off. It cannot be activated when the
Delay function is active.
Turns the Lighting System on and off at maximum intensity.
Press and hold the button for approximately 5 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm
on/off.
Led T3+Led T4 flash twice – Alarm On.
Led T3+Led T4 flash once – Alarm Off.