Lionelo Timon Manual De Usuario página 8

Idiomas disponibles

pulling the plastic level downwards (fig. 11).

NOTE! When using the baby's bed, remember to lock all wheels.

BABY'S BED HEIGHT ADJUSTMENT

The baby's bed height can be adjusted at 6 levels. The product's height can be

adjusted independently from each side, thanks to which it is possible to set an

inclination. The height changing buttons are located on both sides of the product,

just under the top frame of the bed. To change the height, press the button on one

side of the bed, then lift or lower the bed as desired. Do the same on the other side.

WARNING: The maximum permissible inclination of the baby's bed is a difference of

2 levels. The child's head must always be higher than other parts of the body (fig. 12).

NOTE! Before you change the height of the mattress, take the child out of the bed.

FUNCTION OF THE BEDSIDE SLEEPER

Timon baby's bed can be used as an bedside sleeper (attached to parents' bed). Before

you use the product for this purposes, make sure the baby's bed has been placed

properly, and linking belts have been attached and tensed up as requested. The

product must be attached to parents' bed in a way that excludes any gaps between

the product and the mattress. When using, make sure the bedding, quilt, etc. do not

take space in the bed.

NOTE! It is allowed to use the product solely by the beds and/or mattresses

with straight sides. The use of the product by the round or water beds and/or

mattresses is forbidden.

To make use of the bedside sleeper, prepare the product for such use properly.

To do so, follow the points below:

Unzip on both sides of the opening side (fig. 13)

Release the protection by pressing the buttons on the frame and slide the

metal frame tube out of the clips.

Push the baby's bed closer to the parents' bed.

Adjust the height of the cot (fig. 14).

NOTE! When using the baby's bed as an bedside sleeper, the height must be the

same on both sides.

Use the belts to attach the baby's bed to parents' bed. Fasten the belt from

the internal side of the left and right frame, and then wrap around the bed's

frame and fasten it.

‑ 8 ‑