Publicidad
Idiomas disponibles
Idiomas disponibles
❸ Use
3.1 I Operati ng principle
The cleaner is independent of the fi ltrati on system and can therefore operate autonomously. It just simply needs to be
connected to the mains power supply.
It fi nds the best route to move around and clean the areas of the pool for which it has been designed (depending on the
model: bott om only, bott om and walls). Debris is sucked in and stored in the cleaner's fi lter.
The control box is used to remotely control your cleaner and provide initi al diagnosti cs indicators.
3.2 I Pool preparati on
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The appliance must operate in pool water with the following properti es:
Water temperature
Chlorine
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to opti mise the
appliance's performances.
• Remove any thermometers, toys and other objects that might damage the appliance.
3.3 Immersing the cleaner
• Place as much of the fl oati ng cable as possible in the water.
• Place the cleaner into the water using the handle (see image
• Move it slightly in all directi ons so that the air contained in the cleaner escapes (see image
• It is essenti al that the appliance sinks on its own and sett les on the pool bott om (see image
pH
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
).
EN
).
)..
6
Publicidad
