Publicidad
Idiomas disponibles
Idiomas disponibles
7. TROUBLESHOOTING
ISSUES
Refrigerator doesn't work •
Refrigerator
compartment is too
warm
Food is frozen
There is a "waterflow"
noise inside the
refrigerator
There are waterdrops
around the refrigerator's
casing and/or door gap
The compressor is slightly
noisy when starting
Code F1 is displayed
Code F2 is displayed
Code F3 is displayed
Code F4 is displayed
Code F5 is displayed
Code F6 is displayed
Codes F7 or F8 are
displayed
CAUSES / SUGGESTIONS
Make sure the appliance is switched on.
•
Check if the plug is well connected into the socket.
•
Check if the fuse has blown*.
•
Check if the power is supply is malfunctioning or defective.
•
Switching the fridge ON and OFF frequently may cause some delay in the
compressor's functioning.
•
The door is opened too frequently.
•
A large amount of warm or hot food was stored.
•
The refrigerator has been disconnected for a long time.
The temperature was set too low.
No need to worry, it's a normal phenomenon caused by the flow of the refrigerant.
No need to worry, it's a normal phenomenon, the moisture will condense into water when
it comes into contact with the cold surface of the refrigerator.
It is a normal phenomenon; the noise is reduced as soon as the compressor starts
functioning stably.
Possible cause: low voltage.
Adjust the battery protection mode from High to Medium or from Medium to Low.
Possible cause: the condenser's fan is overloaded.
Switch the appliance off and leave it unplugged for 5 minutes then re-start it.
Possible cause: the appliance is turned ON and OFF too often.
Switch the appliance off and leave it unplugged for 5 minutes then re-start it.
Possible cause: the compressor isn't working.
Switch the appliance off and leave it unplugged for 5 minutes then re-start it.
Possible cause: the compressor and the electronics are overheated.
Switch the appliance off and leave it unplugged for 5 minutes then re-start it.
Possible cause: the condenser's fan is overloaded.
Switch the appliance off and leave it unplugged for 5 minutes then re-start it.
Possible cause: the temperature's sensor is faulty.
EN
21
Publicidad
