Vonyx VMM-P500 Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the product be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL ELEMENTS
1. Mic/line Input
Input jacks supporting both XLR and unbalanced ¼" plug.
2. +48V Phantom Button and LED
Press to turn on/off. When turned on, the button will light. Turn on to provide DC+48V phantom power to XLR plug on
MIC mono input. Turn on when using the condenser microphone which is powered by a phantom power.
3. Gain Control
Adjusts the input signal level. To get the best balance between the S/N ratio and the dynamic range, adjust the gain so
that the peak indicator lights only occasionally and briefly on the highest input transients. The -6 to +38dB scale is the
adjustment range.
4. Equalizer High Frequency
This equalizer adjusts the channel's high frequency band (treble). Setting the knob to the mid position produces a fiat
response in the band. Turning the knob to the right boosts the band, while turning to the left attenuates the band.
5. Equalizer Low Frequency
This equalizer adjusts the channel's low frequency band (bass). Setting the knob to the mid position produces a fiat
response in the band. Turning the knob to the right boosts the band, while turning to the left attenuates the band.
6. FX Control
The aux send marked FX offers a direct route to the built-in effects processor and is post-fader and post-mute.
7. Pan
The PAN control determines the stereo position of the channel.
8. Stereo Channel Input
If only L /(MONO) socket is connected, the mixer will send out the same mono signal to L and R outputs.
9. Main Output
Connect active speaker or amplifier to this output.
10. Peak (LED indicator)
The peak indicator lights up red when the output reaches the clipping level.
11. Power On/Off
Turn the device on or off.
12. DSP Select
Press UP or DOWN button to select from 16 DSP.
4
All manuals and user guides at all-guides.com