Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Do not store the emergency key inside the safe.
1. BATTERY INSTALLATION
Open the door, remove the plastic cover located behind
the door and place 4 new 1,5V AA batteries.
2. PROGRAMMING THE OPENING
CODES
This safe allows to program two secret opening codes-
-one standard and one master, from 3 to 6 digits each.
The initial standard code is 000000 and the initial
master code is 888888. For your security, it´s
important that you change them and configure the
codes you desire.
During the process, use the
last digit entered.
Programming the standard code (the safe must be
open):
A. Press 00 and the
display SELECT.
B. Press the 0 button. The screen will display SET.
C. Enter your code (3 to 6 digits) and press the
button. The screen will display DONE.
With the door open, verify that the new code operates
correctly (see section 3, opening the safe).
Programming the master code (the safe may be
open or closed):
A. Press 00 and the
display SELECT.
B. Press the 1 button. The screen will display OLD.
C. Enter the current master code (888888 the first
time) and press the
display SET (if the code entered is incorrect, it will
display ERROR).
D. Enter the new master code (3 to 6 digits) and
press the
button. The screen will display
REPEAT.
E. Enter the new master code again and press the
button. The screen will display DONE (if the code
entered is not the same both times, the screen
will display ERROR).
button to delete the
button. The screen will
button. The screen will
button. The screen will
3. OPENING THE SAFE
Enter either of the two active opening codes, then turn
the door knob in clockwise direction to open the door
within 5 seconds, and inside LED lamp will bright 25
seconds automatically.
If an incorrect code is entered, the screen will display
ERROR1, for a second incorrect attempt it will display
ERROR2, and for a third incorrect attempt it will display
ERROR3 and the system will remain blocked for 5
minutes, indicating by blinking HOLD 5... HOLD 4... etc.
During this time, the keypad cannot be used.
4. CLOSING THE SAFE
Just turn the door knob in anticlockwise direction to
close the door.
5. OPENING WITH THE EMERGENCY
KEY
If you do not have the opening codes, or if the batteries
have run out and an external battery is not available,
you can open the safe using the emergency key.
For this, access the emergency lock. Introduce the key
provided with these instructions and turn it, then turn
the door knob. The safe will open.
Note: In case of an emergency opening due to a wrong
code, the emergency key opens the door but does not
unblock the electronic system.
6. OPENING WITH AN EXTERNAL
BATTERY
If the batteries have run out, you can use the safe by
placing a 9V battery in the power supply located to the
right of the keypad.
Once the safe is open, replace the batteries.
7. OTHER CONTROL ELEMENTS
SCREEN CONTROL: To configure the screen so it does
not display the digits that are entered, press the
button and then the 3 button. If you would like the
screen to display what you enter, press the
button again.
SOUND CONTROL: To use the safe in silent mode,
press the
button and then the 6 button. If you
<EN>
3
Publicidad
