pellenc EXCELION ALPHA Manual De Instrucciones página 77

LED status
Incident /
breakdown of the battery
The tool stops
I
during use
The power
gradually in-
creases and
"C°" flashes I
alternately
on the digi-
tal display.
7.2. SUMMARY OF DISPLAY SCREEN MESSAGES
Note
Error messages appear on the digital display on the tool handle.
Diagnostics display codes
E1
E2
E4
E5
E9
Important
Never attempt to dismantle the tool, under penalty of cancellation of the warranty. Contact your authorised
repair person.
GRASS STRIMMER EXCELION ALPHA
53_144013_C
Probable cause
of the tool
handle
Trigger no
longer functions
The power cord
of the backpack
battery is cut
The tool has
reached its tem-
perature limit
Off
The battery is flat
Unintentional
pressing of the
tool's on/off but-
ton for more
than 4 seconds.
The tool has
On reached thermal
safety shutoff
Name
Abnormal current
Battery communication fault
Tool temperature too high
HMI board communication error
Sensor fault
Checks Solutions
At an autho- Change
rised PEL- the trigger
LENC distributor or sensor
Check the condi- Change
tion of the cord the cord
See Sec-
See Section 7.3, tion 7.3,
"Thermal safe- "Thermal
ty shutdown" safety shut-
down"
When stopped, Recharge
check the battery the battery
charge level shown (if less than
in the side window 10% charged)
The battery LED
Switch the
and digital dis-
tool on again.
plays are off.
See Sec-
See Section 7.3, tion 7.3,
"Thermal safe- "Thermal
ty shutdown" safety shut-
down"
Repairer
Authorised
PELLENC
distributor
Pellenc au-
thorised
distributor
User
Authorised
PELLENC
distributor
User
User
User
Authorised
PELLENC
distributor
77