Ohyama WOOZOO IHF-1201G-E Manual De Usuario página 16

Introduction for buttons on remote controller
Note:
● " , , " may not be available. When air conditioner receives this signal,
the air conditioner will blow fan automatically.
● Press this button continuously more than 2s, the main unit will swing back an
forth from up to down, and then loosen the button, the unit will stop swinging
and present position of guide louver will be kept immediately.
● Under swing up and down mode, when the status is switched from off to
if press this button again 2s later,
press this button again within 2s, the change of swing status will also depend
on the circulation sequence stated above.
8
SLEEP button
"
● Press this button, can select Sleep 1 (
cancel the Sleep, circulate between these, after electrified, Sleep Cancel is
defaulted. Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for
one hour, the main unit setting temperature will increase 1°C , two hours,
setting temperature increased 2°C , then the unit will run at this setting
temperature; In Heat mode: sleep status after run for one hour, the setting
temperature will decrease 1°C , two hours, setting temperature will decrease
2°C , then the unit will run at this setting temperature.
● Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting
a group of sleep temperature curve.
● Sleep 3-the sleep curve setting under Sleep mode by DIY;
(1) Under Sleep 3 mode, press "Turbo" button for a long time, remote controller
enters into user individuation sleep setting status, at this time, the time of remote
controller will display "1hour", the setting temperature "88" will display the
corresponding temperature of last setting sleep curve and blink (The first entering
will display according to the initial curve setting value of original factory);
(2) Adjust "▲" and " " button, could change the corresponding setting
temperature, after adjusted, press "Turbo" button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer position on the
remote control, (that are "2hours" or "3hours" or "8hours"), the place of setting
temperature "88" will display the corresponding temperature of last setting sleep
curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature setting
finished, sleep, curve setting finished, at this time, the remote controller will
resume the original timer display; temperature display will resume to original
setting temperature.
● Sleep3- the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting
sleep curve, enter into user individuation sleep setting status, but do not change
the temperature, press "Turbo" button directly for confirmation. Note: In the
above presetting or enquiry procedure, if continuously within 10s, there is no
button pressed, the sleep curve setting within 10s, there is no button pressed,
the sleep curve setting status will be automatically quit and resume to display
status will switch to off status directly; if
), Sleep 2 ( ), Sleep 3 (
13
,
) and
In
th
b
o
9
Pre
con
am
tem
FE
● P
t
o
is
u
10
● T
"
ic
"
T
la
P
r
s
● T
"
ic
"
T
la
P
d
u
No
● U
● B
● A
A
t
p