Publicidad
Idiomas disponibles
Idiomas disponibles
Installation of indoor unit
2. Make the power connection wire go
through the cable-cross hole at the back
of indoor unit and then pull it out from the
front side.
3. Remove the wire clip; connect the power connection wire to the wiring terminal
according to the color; tighten the screw and then fix the power connection wire
with wire clip.
Note: the wiring board is for reference only, please refer to the actual one.
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
Note:
● All wires of indoor unit and outdoor unit should be connected by a professional.
● If the length of power connection wire is insufficient, please contact the supplier for
a new one. Avoid extending the wire by yourself.
● For the air conditioner with plug, the plug should be reachable after finishing
installation.
● For the air conditioner without plug, an air switch must be installed in the line. The
air switch should be all-pole parting and the contact parting distance should be
more than 3mm.
Cable-cross
hole
Power connection
wire
N
(
) 1
2
2
3
Blue
Black
Brown
Yellow-
green
Outdoor unit connection
35
In
St
1.
2.
St
1.
2.
3.
4.
5.
Publicidad
