Cooling System; Troubleshooting Guide - AllTrade TRADES PRO 830271 Manual De Instrucciones

Impurities entering pressure pump can cause internal damage.

COOLING SYSTEM

The air louvers, located in and around the Pressure Washer housing must be kept clean and
free of any obstructions to ensure proper air cooling of the motor and pump during operation.
LUBRICATION
This Pressure Washer does not require any maintenance on the pump or motor. Both assem-
blies are pre-lubricated and sealed, requiring no additional lubrication.
persists or became worse, contact our customer service department.
Problem
Unit will not start (when
trigger is depressed)
Do not operate Pressure Washer without screen filter in place.
A small amount of oil leakage is normal. If oil leakage

TROUBLESHOOTING GUIDE

Probable Cause
1. Unit is not turned on.
2. Loose or disconnected
plug.
3. GFCI has tripped.
4. Motor thermal switch
has tripped.
20
Solution
1. Turn ON/OFF Switch
into ON position.
2. Reconnect Plug.
3. Push reset button on
plug.
4. Allow to cool and restart
unit.