Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Heater description
Material losses
- If connecting the heater via a wall outlet plug, en-
sure that it is easily accessible once the heater has
been installed.
- Never install the heater directly below a wall socket.
- Ensure that the power cable is not in contact with
any heater components.
10.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
11. Heater description
11.1 Standard delivery
The following are delivered with the heater:
- Wall mounting bracket (hooked into the heater)
- Power cord with 120 V plug (120 V models only, attached)
12. Installation
12.1 Installation site
Installation in bathrooms
WARNING Electrocution
When installing the heater in rooms with a bath and/or
shower, the heater may only be connected to a standard
socket or hard-wired outside safety zones 0, 1 and 2.
Any electrical connections must be at least 24˝ (600 mm)
away from a bath or shower. If in doubt, consult a qual-
ified contractor.
3
2
Electrical safety zones in the bathroom
10
| CNS Trend & CNS Plus
1
0
12.2 Minimum clearances to hard surfaces
WARNING Fire
Combustible materials such as furniture, papers, clothes
and curtains must be kept at least 3 feet (0.9 m) from
the heater.
Never place any flammable, combustible or insulating
objects or materials, such as laundry, blankets, maga-
zines, containers with floor polish or gasoline, spray cans
or similar on the appliance or in direct proximity to it.
ANY HARD SURFACE
FLOOR
12.3 Installing the wall mounting bracket
The heater is intended for wall mounting using the supplied wall
mounting bracket.
Never install the heater directly below a wall outlet.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a level if the floor is uneven or sloping.
1
2
a a a
¾
2 cm
3
4
www.stiebel-eltron-usa.com
Publicidad
