Metabo HPT EC 710SA Manual De Instrucciones Y Instrucciones De Seguridad página 10

English
4. Confi rm the power receptacle
If the power receptacle only loosely accepts the plug,
the receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a faulty receptacle is used, may cause
overheating, resulting in a serious hazard.
5. To check the safety valve.
Before starting compressor, pull the ring on the safety
valve to make sure that the safety valve operates
smoothly. (Fig. 3) Do not use compressor if the safety
valve is stuck or does not operate smoothly. Have
defective safety valve replaced by a metabo HPT
authorized service center.
WARNING:
WARNING:
6. Right running position
Always operate the compressor in a stable and
secure position to prevent accidental movement of
the unit. Never operate the compressor on a roof
or other elevated positon. Never use on a ladder or
unstable support. Use an additional air hose to reach
high locations.
Operate the compressor in an open area at least 18 in.
(45 cm) away from any wall or object that could restrict
the fl ow of fresh air to the ventilation openings. Do not
place rags or other objects on or near these openings.
10
Safety valve
Fig. 3
Drain tank to release air
pressure before pull the ring
on the safety valve.
Risk of bursting.
If the safety valve does
not work properly, over-
pressurization may occur,
causing air tank rupture or an
explosion.
WARNING:
NOTE: When operating or storing the compressor, set 3
rubber bumpers downward on the fl oor (Refer to
Fig. 1).
7. Temperature
Operating temperatures are between 32°F and 104°F
(0°C and 40°C).
CAUTION: Never operate in temperatures
below 32°F (0°C) or above 104°F
(40°C).
8. Air hose
Check the air hose for weak or worn condition before
each use, making certain all connections are secure.
Do not use it if a defect is found. Purchase a new
air hose or notify a metabo HPT authorized service
center for examination or repair.
Make sure the air hose is free of obstructions or
snags.
If it is entangled or snarled, the air hose can cause
loss of balance or footing and may become damaged.
Keep the air hose away from sharp objects, chemical
spills, oil, solvents, and wet fl oors.
9. Breaking in the pump.
(1) Turn the knob of the pressure reducer fully clockwise
to open air fl ow.
(2) Place the power switch in the "OFF" position and
insert the plug into the receptacle.
(3) Open the drain cock completely.
(4) Turn the air compressor "ON" and run it for 10 minutes
to break in the pump parts.
(5) Place the power switch in the "OFF" position.
(6) Close the drain cock.
TRANSPORT
Turn off the power switch, and disconnect the plug from
the power source before transport the compressor.
Transport the compressor in the correct manner.
When transporting the compressor, grasp the handle.
A portable compressor can
fall from a table, workbench,
or roof causing damage to the
compressor and could result
in serious injury or death.