Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BLADES
Insert blade into the slot on flywheel. Install blade with screws and washers that are pre-assembled.
Aligning each of the holes and tighten all screws securely. Repeat this process for remaining blades.
INSTALLING THE LIGHT KIT
Note: Before starting installation, disconnect the power by turning off the circuit breaker or removing
the fuse at fuse box.
1.
Loosen 2 screws and remove 1 screw from the base plate
2.
Connecting the wire plug from LED light source to the wire plug from fan motor assembly.
3.
Install the light pan to the base plate by using the screws that are loosened and removed
previously. Tighten all screws securely.
4.
Install the glass shade by turning clockwise in position. Make sure the glass is locked in place.
Canopy
Downrod & Ball
Bolt
Coupling
Coupling Cover
Lock pin
Set screw
EN
15
Publicidad
