Marshall DSL20CR Guia De Inicio Rapido página 8

ENGLISH
REAR PANEL FUNCTIONS
DSL20CR
Designed by Marshall Amplification Plc,
Bletchley, Milton Keynes, England
MADE IN VIETNAM
16
DSL20HR
22
16. MAINS INPUT
The supplied mains power lead is connected
here. The mains input voltage rating that your
amp has been built for is shown on the rear
panel.
Warning: before powering on, ensure the amp is
compatible with the mains voltage of the country
that the amp is being used in. If you have any
doubt, please get advice from a qualified person.
17. FX LOOP RETURN
Connect the output of an external FX pedal or
processor.
18. FX LOOP SEND
Connect the input of an external FX pedal or
processor.
19. F/S
Connect the supplied channel footswitch here
(PEDL-90012).
20. AUDIO IN
Connect an external device here to practice with
or jam along to music.
21. EMULATED OUT
Frequency-compensated line level output
7
17
21 20 19 18
18 19 20 21
17
for headphones. This output features cabinet
emulation by Softube®. This means the sound
from this output includes simulation of the sound
of a speaker and a cabinet.
Warning: When using the DSL20HR head for
'silent' practice or DI recording, only disconnect
the speaker cabinet from the amplifier's rear
panel while the amp is switched off. Never unplug
the speaker cable from the speaker cabinet while
it is still connected to the amplifier rear panel.
This may damage your amp.
22. SPEAKER OUTPUTS
Connect an optional 1 x 16Ohm extension
speaker cabinet, or 1x8Ohm cabinet, or
2x16Ohm cabinets for the DSLCR combo.
Warning: Any other speaker configuration may
stress or damage the amp.
22
16