Bissell POWERFILTER 1793 Serie Manual Del Usuario página 7

Maintenance: Empty Dirt Tank
1
Remove tank by pressing the release
button on the tank handle.
3
Empty contents
of dirt tank into
trash container,
and gently shake
the top handle to
remove build up.
NOTE: If you notice excess build up around the top of the tank, before removing
top piece, gently tap the tank to allow contents to settle.
Maintenance: Pre-Motor Filter
1
Remove the dirt tank to
locate and remove the
pre-motor filter. Pinch
the filter and lift to
remove from unit.
WARNING
To reduce the risk of electrical shock, turn power switch off and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
2
4
2
While holding over trash,
gently separate filter layers
(being careful not to rip
filter layers) and shake out
excess debris.
Grasp handle on
back of tank with
one hand and the
top handle with
the other. Twist
the top handle
counterclockwise
until latches release.
Pull the top handle
straight up from the
dirt tank.
Place the top handle
straight down into
the dirt tank. Align
the latch arrows and
gently twist clockwise.
When fully assembled,
the tank will click into
place. Replace the tank
back onto the vacuum
– it will click when fully
installed.
NOTE: Filter can be
rinsed in warm water.
Allow it to completely
dry before replacing. If
the filter is damaged,
replace the part.
NOTICE:
Your vacuum model
includes a Febreze® filter.
Over time with washing,
you will notice a reduction
in the scent strength.
www.BISSELL.com
7