EGAmaster ROSCAMATIC 100-4 Manual De Instrucciones página 10

B) LOOSE THE PIPE
A sharp jerk in clockwise direction will release the pipe.
B
C) PREPARATION FOR THREADING
C1- Select the correct die head and dies as required.
C2- Insert the set of dies in the die head as numbered and make the die thread coincide with the
positioning ball of the die head, until a "klick" sounds.
C3- Once the dies are positioned, turn the lever nut to lock until you get the desired measure.
C4- Set the thread length desired by means of the dial.
C1
D) THREADING
D1- Raise cutter and reamer out of the way.
D2- Lower the die head to the carriage in such a way that the extremity of die head body is locked
by the carriage buttom.
D3- Set the speed change lever for the size indicated.
D4- Switch on the machine checking that the oil is flowing correctly from the die head, if not, you
can regulate it by the oil flow adjustmen knob on the right bottom part of the carriage.
D5- Advance the carriage until the dies engage the pipe pressing it to start the threading and kee-
ping it until 2 threads are produced, releasing after because the thread itself would drive the
carriage during the rest of the threading.
10
B
C2 C3 C4