Publicidad
Idiomas disponibles
Idiomas disponibles
9.3
BLOWING FEATURE
16
15
It can blow sawdust and other debris. Complete the steps
below to use your machine as a blower.
1. Align either of the grooves (16) in the tube with the tabs
(15) on the hose.
2. Attach the desired accessory to the end of hose.
3. Start the machine.
9.4
OPERATION TIPS
•
The filter must always be in correct position to avoid
leaks and possible damage to the machine.
•
When you use your machine, it will be necessary for you
to empty the collection tank and clean the filter at more
frequent intervals to maintain peak vac performance.
•
When the liquid in the collection tank reaches a
predetermined level, the float mechanism will rise
automatically to cut off air-flow. This will cause the
suction stop and the higher motor noise. When this
happens:
1. Turn off the machine.
2. Remove the battery pack.
3. Empty the collection tank.
•
Dry the filter after you use the machine to avoid mildew
and damage to the machine.
10
MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
English
Remove the battery pack from the machine before
maintenance.
10.1
CLEAN THE FILTER
Allow the filter to dry before you store or picking up debris.
Often clean your filter to maintain peak vac performance.
Clean a dry filter:
•
Cleaning should be done outdoors and not in the living
quarters.
•
You can use a small brush to clean the dust and debris.
•
For thorough cleaning of dry filter with fine dust (no
debris), run water through it as described under "Cleaning
A Wet Filter"
Clean a wet filter:
1. Remove the filter from the machine.
2. Run water through the filter from a hose or spigot.
Check the cartridge filter for tears or small holes after
cleaning. Do not use a cartridge filter with holes or tears in
it. Even a small hole can allow dust to come out of your
machine. Replace it immediately.
10.2
CLEAN THE MACHINE
To keep your machine looking its best, clean the outside with
a cloth dampened with warm water and mild soap.
To clean the collection tank:
•
Dump debris out.
•
Wash collection tank with warm water and mild soap.
•
You can use a small brush to clean the dust and debris.
•
Wipe out with dry cloth.
To disinfect the collection tank:
1. Pour 1 gallon of water and 1 teaspoon chlorine bleach
into the collection tank.
2. Let solution stand for 20 minutes, carefully swishing
every few minutes, making sure to wet all inside surfaces
of the collection tank.
3. Empty collection tank after 20 minutes. Rinse with water
until bleach smell is gone. Allow collection tank to dry
completely before sealing the motor on the collection
tank.
Disinfect the collection tank before storage or as needed.
9
WARNING
NOTE
NOTE
NOTE
EN
Publicidad
