Craftsman 247.77661 Manual Del Operador página 11

Coupler
Hitch
Adjustable Stand
Assembly
Engine Controls
Choke Control
Fuel Valve
Recoil Starter Handle
WARNING
Read this operator's manual and the safety rules before operating
your log splitter. Compare the illustrations below with your equipment
to familiarize yourself with the location of various controls and adjust-
ments. Save this manual for future reference.
BEAM LOCKS
These two locks are used to secure the beam in the horizontal or
the vertical position. The vertical beam lock is located on the tanks
bracket. The horizontal beam lock is located on the beam support latch
bracket.
WEDGE
The wedge is used to split the wood.
COUPLER HITCH
The coupler hitch is at the end of the tongue and attaches to a tow ball
for transportation purposes.
MEETS ANSI SAFETY STANDARDS
Craftsman Log Splitters conform to the safety standard of the American National Standards Institute (ANSI).
OPERATION
Cylinder
Tongue
Throttle Control
Control Handle
Log Dislodger
Wedge
Vertical
Beam
Lock
Figure 11
Be familiar with all the controls and their proper operation. Know how
to stop the machine and disengage them quickly.
Always wear safety glasses when operating this equipment or while
performing any adjustments or repairs on it.
CONTROL HANDLE
The control handle is used to move the wedge up and down to split
wood. The control handle has three positions; Forward, Neutral and
Reverse. See the "Using the Log Splitter" section for instructions.
LOG DISLODGER
The log dislodger is designed to remove any partially split wood from
the wedge. This may occur while splitting large diameter wood or
freshly cut wood.
RECOIL STARTER HANDLE
Used to start the engine.
11
Horizontal
Beam Lock
Beam Assembly
End Plate
Log
Tray
Reservoir
Tank
WARNING
WARNING