Publicidad
Idiomas disponibles
Idiomas disponibles
Power On: Long press the power button until the display lights up.
Power Off: Long press the power button until the display goes out and the system is off.
l. Battery power display: it shows the current remaining battery capacity.
2. Power off automatically: After the display is idle for more than 5 minutes, the Electric
scoo- ter automatically turns off.
Change display information: When the Electric scooter is on, short press the power button ,
change the showing data on the display, TIME, ODO, DIS and other characters respectively.
When it is showing time, it indicates the running time after switching on. The time will be
cleared after switching off. When it is showing DIS, it indicates the driving distance after
switching on, and it will be cleared after power off. When it is showing ODO, it indicates the
total mileage, which will be retained unless it is manually cleared.
Change the gear: Short press
Gear 2 is medium speed, and Gear lis slow speed).
Acceleration: Gently press the accelerator button to speed up (The depth of the press is
related to the gear level you have set).
Deceleration: Gently press the deceleration dial to slow down. The deeper the press, the
greater the deceleration (the deceleration is relevant to the formation of the press, and
pushing too hard can not increase the braking force and may cause damage to the brake
dial).
Clear total mileage: Press
to switch on the Electric scooter, and the total mileage will be cleared.
lmportant: Press
▲
select P3 mode, when para meter value is O, it will start with zero. When para meter value
is l, it will start with non-zero.
(Zero start: When starting, the Electric scooter in a stationary case, press the accelerator to
start driving.)
(Non-zero start: When starting, the Electric scooter is static, press the accelerator and the
Electric scooter does not work, push the Electric scooter manually to start driving, the
Electric scooter works. factory default is non-zero start. )
You have to manually move the Electric scooter with your foot before the accelerator
button works.
9. Electric scooter riding
l. Press
▲
and
▼
buttons to adjust speed level.
2.Press the accelerator button to accelerate, so you can drive.
3.Press the brake button to brake.
4.When you press the accelerator and electric brake button at the same time, the Electric
scooter will automatically brake
5.For safety, the rear wheel brake system must be used when driving at high speed.
6.When driving at night, press the headlight switch button to turn on the headlight.
▲
or
▼
▲
and ▼buttons at the same time, then press the power button
and
▼
buttons at the same time, then press the power button
Rear break
button to change the gear level (Gear 3 is fast speed,
and
Publicidad
