Heath Zenith SL-4190 Serie Manual Del Usuario página 7

SPECIFICATIONS
Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . Up to 180°
Electrical Load . . . . . See rating on fixture
Sensor Capacity . . . Up to 360 Watts (3.0 A.)
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
Time Delay . . . . . . . 1, 5, 10 minutes
D B Timer . . . Off, 3, 6 hours, dusk-to
®
ual rite
HeathCo LLC reserves the right to discontinue
products and to change specifications at
any time without incurring any obligation
to incorporate new features in products
previously sold.
SYMPTOM POSSIBLE CAUSE
Light will not 1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this is
a new installation.
Light comes on 1. Light control may be installed in
in daylight.
a relatively dark location.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
Light comes on 1. Light control may be sensing small
for no apparent
animals or automobile traffic
reason.
(Reduce sensitivity).
2. Sensitivity is set too high. (Re-
duce sensitivity.)
595-5628-08
All manuals and user guides at all-guides.com
[varies with surrounding
temperature]
for maximum wattage
Maximum Tungsten
Incandescent
MANUAL MODE
dawn
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE
Light stays on 1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes
1. Light control is in the Test
on and off.
2. Heat being reflected from other
7
a heat source like an air
vent, dryer vent, or brightly-
painted heat-reflective surface.
(Reduce sensitivity.)
(Switch to Auto.)
B
ual
mode.
duce sensitivity.)
mode and war ming up.
(Flashing is normal under
these conditions).
objects may be affecting the
sensor. (Reduce sensitivity.)
®
rite