Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9. Product Maintenance
1. Lubrication
When the running belt is used for a period of time, it must be Iubricated with special methy silicone oil.
Advice:
1 hour or less per week
Less than 3 hours per week
3-6 hours per week
More than 6 hours per week
Do not lubricate too much. It is not the more lubricants, the better.
Remember: Proper lubrication is an important factor in improving the life of the treadmill.
2. The method to check if you need to add lubricant.
Grab the running belt and touch the middle of the running belt back
with your hands as much as possible.You don't need to add lubricant if you have silicone on your
hand (a little damp). You have to add lubricant if the pad is dry and there is no silicone on your hand.
The step of lubricating on the running plate (as shown in
the right picture).
Stop running and fold the machine.
Lift the running belt of the underside of the main body,
and put the oil pot as far as possible into the middle of
the running belt. And spray methyl silicone oil inside
the running belt and all the contacting area.
You can keep the treadmill running in speed of 1km/h to
evenly lubricate then step on the running belt from left
to right. After a few minutes, the methyl silicone oil can
be completely absorbed by the running belt.
3. Adjust tightness of running belt. All treadmills shall be adjusted for tightness before delivery and
after installation. However, the running belt may be loosened after a period of use.
For exampIe, the treadmill would have stopping and slipping problem during exercise. Adjust bolts
of running belt with the left and right synchronous as per clockwise direction to half a circle as the
unit when this phenomenon occurs.The user might slip if the running belt is too loose.
But it is not good to be too tight. It is easy to increase the load of the motor therefore damage the
motor, running belt and roller, etc.
4. Running Belt Deviation Adjustment
All treadmills need to be adjusted with the running belt before delivery and after installation.But the
running belt may be deviated after a period of use which may be caused by the following reasons.
①The main body is not placed smoothly.
②The feet of users are not in the center of the running belt.
③The user runs with uneven force between the feet.
Product Maintenance 17
lubricate once every 6 months
lubricate once every 3 months
lubricate once every 2 months
lubricate once a month
18 Service Commitment
It will return to normal after a few minutes of no-load rotation if deviation is caused due to wrong
usage. It should be adjusted with 6mm wrench at a half circle as the unit for deviation of non-
recover automatically.
Please adjust left bolt with clockwise or right bolt with
counterclockwise if running belt is left deviation.
The running belt deviation is not within the scope of warranty. And it is mainly maintained by
the user according to the manual. Running belt deviation will seriously damage the running belt.
The mistake must be detected in time and corrected.
5. Adjustment of Motor Belt (as shown in the right picture).
All treadmills have been adjusted for the motor belt before and after installation, but they may still
be out after a period of use. If the loose slip occurs, the user could adjust the belt according to the
following instructions.
Adjustment Steps:
①.Adjust the parallelism of the motor
with a wrench. Turn the bolt half a turn
counterclockwise.
②.Turn the belt tightening bolts
clockwise half a circle.
NOTE: Clean belt and pulley grooves
regularly.
10. Service Commitment
We provide statutory warranty service in the country where you purchased.
Regulatory compliance, full text Supplier DoC is avaliable at the official website.
Please check out our official website to learn more: www.mobvoi.com/products
Please contact us if you experience any problems. Customer service: support@mobvoi.com
The limited warranty applies for T4000 electric treadmill. Within warranty period of normal use,
such as non-human damage, Mobvoi can provide users with free accessories. After the expiration
of the warranty period, preferential prices of spare parts may be offered to previous buyers.
Manufacturer: Jiangxi EQi Industrial Co.,Ltd.
Please adjust right bolt with clockwise or
left bolt with counterclockwise if running
belt is right.
EN
Publicidad
