Publicidad
Idiomas disponibles
Idiomas disponibles
Instrument and control functions
Brake pedal
The brake pedal is located on the right
side of the motorcycle. To apply the rear
brake, press down on the brake pedal.
EN
3
ABS
The anti-lock system (ABS) is designed to
prevent locking of wheels during braking.
The ABS controls the braking power auto-
matically and intermittently, allowing the
wheels to gain grip on the road and incre-
asing the vehicle stability.
• For more efficiency, use the front
brake and the rear one at the same
time and in the same manner, as on
a vehicle without ABS.
• The ABS cannot compensate the
road harsh conditions or an impro-
per use of the braking system. Du-
ring braking, act with the same care
as in case of a vehicle without ABS.
• During cornering, it is advisable to
use both brakes in a soft manner and
to reduce the speed gradually. As on
a traditional braking system, a hard
and excessive braking may cause a
sudden lock of the wheels and the
motorcycle loss of control.
• During braking, the ABS will not
prevent the rear wheel from raising
form the ground.
• The ABS control unit always uses the
vehicle speed data and wheel rota-
tion speed. Do not use non-appro-
ved tyres to avoid ABS malfunctio-
ning and cause an extension of the
braking distance.
3 - 14
WARNING
The ABS cannot protect the rider from
any danger and it is necessary to drive
the vehicle in a responsible way. It is
important to know the ABS operation
and its limits.
It is the responsibility of the rider to
drive in a responsible way, according
to the type of asphalt, road and traffic
conditions.
NOTE
• The ABS light may go on during ex-
treme driving conditions or in situa-
tions that lead to a different rotation
speed of the front and rear wheels. In
this situation, it is necessary to bring
the ignition key to "OFF" position, and
then back to "ON" position.
• If the light will still stay on even after
having reached or exceeded the
speed of about 5 km/h, contact an
authorized Benelli service centre for
checking.
• When the ABS is working, a pulsation
may be felt on the brake lever or the
pedal.
• The ABS is not active when the sp eed
is below or equal to about 5 km/h.
• The ABS does not work in case of low
battery.
Publicidad
