Publicidad
Idiomas disponibles
Idiomas disponibles
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the effect to the mains, the LED Z-224 RGB DMX starts running.
With the POWER-switch, you can switch the LED Z-224 RGB DMX on and off. This unit has two operating
modes. It can be run as a Stand Alone-unit or DMX-controlled.
Stand Alone-Mode
In Stand Alone Mode you can use the LED Z-224 RGB DMX without a controller.
You can do without a controller as the LED Z-224 RGB DMX features a built-in microphone, which provides
automatic sound control. You can adjust the sensitivity with the rotary-control on the rearpanel.
DMX-Controlled Operation
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
DMX-Protocol
Channel:
Value:
1
0 - 255
2
0 - 255
3
0 - 255
4
0 - 160
161 - 240
241 - 255
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Characteristic:
Red
0 - 100%
Green 0 - 100%
Blue
0 - 100%
Dimmer
Strobe 1-23 Hz/Sec.
Light on
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
19/37
00029285.DOC, Version 1.0
Publicidad
