Stihl FS 260 C Manual De Instrucciones página 39

Cleaning the air filter
Loosen filter cover mounting
N
screws.
Remove the filter cover.
N
Clean away loose dirt from around
N
the filter (5) and inside the filter
cover.
Knock the filter (5) out on the palm
N
of your hand or blow it clear with
compressed air from the inside
outwards.
In case of stubborn dirt or sticky filter
fabric:
Wash the filter in a clean, non-
N
flammable solution (e.g. warm
soapy water) and then dry.
Always replace a damaged filter.
FS 260 C, FS 360 C
Spark Plug
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
Fit a new spark plug after approx. 100
operating hours or earlier if the
electrodes are badly eroded.
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
Removing the Spark Plug
1
Rotate the screw (1) in the cap (2)
N
until the screw head projects from it.
3
Lift the front of the cap (2) and push
N
it to the rear to disengage.
Leave the cap to one side.
N
Pull off the spark plug boot (3).
N
Unscrew the spark plug.
N
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
Remove spark plug – see "Starting /
N
Stopping the Engine".
Clean dirty spark plug.
N
English
A
37