Hotpoint Ariston HNB 9.5S AM X/HA Manual De Instrucciones página 38

Replacing the bulbs
GB
Disconnect the unit from the mains and remove the grease
Caution! Make sure the bulbs are cool before touching
them.
1. Extract the guard by prising
screwdriver or something
similar.
Use only bulbs of the
same type (for details,
see the technical data in
the following manual).
Electrical cable
If the power cable is damaged, it can be replaced by the
manufacturer or his technical service, to prevent any
attendant risks.
SCRAPPING
The unit is marked for conformity with European Directive
2012/19/EC, Waste Electrical and Electronic Equipment
(WEEE). By ensuring that the unit is scrapped properly,
the user contributes to safeguarding the environment and
public health.
The symbol on the product or on its accompanying
documents indicates that the product may not be treated
as domestic waste but must be handed over to a sorting
centre for electrical and electronic waste. Dispose of it
further information on the handling, recovery and recycling
of this product, contact the local authority, domestic waste
disposal service or the reseller from whom you purchased it
38
Troubleshooting
If something does not work, make the following simple
checks before contacting Technical Service:
If the hood does not operate:
Check that:
Check that:
amount of smoke and steam being produced.
air in.
If the hood turns off during normal operation:
Check that:
In case of faulty operation, before contacting Technical
least 5 seconds by pulling its plug, then reconnect it. If the
fault persist, contact Technical Service.