Hisense Hi-Therma Serie Manual De Instalación Y Mantenimiento página 21

UNIT INSTALLATION
6.3 WALL MOUNTING
?
N O T E
Installation procedure
1 Wall mounting procedure
2 Water piping connection
3 Drain pipes connection
4 Refrigerant piping connection
5 Power and transmission wiring connection
6 Cover assembly
7 Test and check
Wall mounting procedure
!
C A U T I O N
Make sure the wall has adequate strength to hang weight of the indoor unit.
1 Fix the wall support (factory-supplied accessory) to the wall.
Drill 3 holes according to the circular hole position of the wall support as shown below, and the hole diameter shall meet the
requirements of M8 expansion bolts.
Using 3 M8 expansion bolts Fix the wall support to the wall. Make sure that the wall support is completely levelled.
2 Hang the indoor unit on the wall support, using the square hole on the back panel of indoor unit. At least two persons are required
in order to lift the unit because of its weight.
The square
hole
15 65
Complete wall
support installation
Unit: mm
65
160
9
Wall support
Expansion bolt
Complete hanging