Teka CPX 15 Manual De Instrucciones página 29

Installation instructions
Before installation
Check that the input voltage indicated on the
characteristics plate is the same as the voltage of
the power outlet you are going to use.
Open the drawer
accessories and remove the packing material.
Attention! The front surface of the crockery
heater may be wrapped in a protective film.
Before using the crockery warmer for the first
time, remove this film carefully.
Make sure that the crockery warmer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact
Service.
Attention: the power socket should be easily
accessible after the crockery warmer has been
installed.
The crockery warmer should only be built-in in
combination with those appliances indicated by
the manufacturer. If it is fitted in combination
with other appliances, the guarantee is no
longer valid since it is impossible to guarantee
that the crockery warmer will work correctly.
Installation
To build-in the crockery warmer in combination
with another appliance there must be a fixed,
interim shelf in the housing unit to support the
weight of both appliances.
The appliance to be combined with the crockery
warmer will be placed directly on the latter without
any need to have a separating shelf.
To build-in the appliance which is combined with
the crockery warmer, follow the instructions set
out in the respective instructions and fitting
booklet.
and take out
the Technical Assistance
The relevant installation dimensions are indicated
in mm in the diagrams shown at the end of this
booklet. Proceed as follows:
1. Place the crockery warmer on the shelf and
all the
slide it towards the interior of the niche in
such a way that it is centred and completely
lined up with the front of the unit.
2. Check that the crockery warmer's frame is
properly levelled and is sitting evenly on the
shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the two
screws provided.
EN
27