Publicidad
Idiomas disponibles
Idiomas disponibles
FirEbox PackagE contEnts
Q
1
FIREBOx
R
1
REMOTE
S
2
CR2032 BATTERy
T
3
METAL TRIM
U
7
FIREBOx TRIM SCREw
assEmbly
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is RED and located inside the packaging, taped to the top box. DO NOT discard
any pieces.
1. Locate the base (C). Insert and tighten 6 cam lock dowels (b) into
the base (C). Make sure the threaded side is down so you can inset
and tighten each cam lock dowel (b) into each hole in the base (C).
Locate the top (A) and place it finished side down on a soft clean
surface. Insert and tighten 6 cam lock dowels (b) into the top (A).
Make sure the threaded side is down so you can insert and tighten
each cam lock dowel (b) into each hole in the top (A). Insert 2 wood
dowels (c) into the holes on the underside of the front of the top A.
Line up the holes in the top trim piece J with the wood dowels in the
top A. Push piece J down until flush with the top A. Secure piece J
to top A by inserting 3 long screws (d) into piece J and tightening
until secure.
2. Locate the left and right top side panels (D & E). Insert 6 wood
dowels (c) into the edges of each panel as shown.
Q
Hardware Used
b
Cam Lock Dowel
c
wood Dowel
d
Large Screw
Hardware Used
c
wood Dowel
U
AAA
T
R
S
C
J
A
x 12
x 2
x 3
D
E
x 12
AAA
3
Publicidad
