Craftsman WEEDWACKER INCREDI-PULL 316.731700 Manual Del Operador página 12

This unit can be started with an optional Speed Start™ accessory
(items sold separately). Please refer to the Speed Start™ accessory
operator's manual for the proper use of this feature.
Please contact your local Craftsman retailer, call 1-800-469-4663 or
visit www.craftsman.com for more information.
STARTING INSTRUCTIONS
1. Check the oil level. Refer to Checking the Oil Level.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 9).
3. Slowly press and release the primer bulb 10 times (Fig. 10).
4. Move the choke lever to Position 1 (Fig. 11).
5. Crouch in the starting position (Fig. 12).
6. Insert the Speed Start™ accessory into the Speed Start™ port
(Fig. 13). Refer to the Operation section of the Speed Start™
accessory operator's manual.
NOTE: SQUEEZE and HOLD the throttle control for ALL further steps.
7. Squeeze and hold the throttle control (Fig. 9). Run the Speed
Start™ accessory for 2 seconds.
8. Continue to squeeze the throttle control. Move the choke lever
to Position 2 (Fig. 11).
9. Continue to squeeze the throttle control. Run the Speed Start™
accessory in intervals no longer than 2 seconds each until the
unit starts.
10. Remove the Speed Start™ accessory from the unit.
11. Continue to squeeze the throttle control. Allow the engine to
warm up for 30 to 60 seconds.
12. Continue to squeeze the throttle control. Move the choke lever
to Position 3 (Fig. 11) and continue warming the engine for an
additional 60 seconds. The unit may be used during this time.
IF... the engine does not start, begin the starting procedure with step 3.
IF... the engine fails to start after a few attempts, move the choke
lever to Position 3 and squeeze the throttle control. Run the
Speed Start™ accessory in intervals no longer than 2 seconds
each until the unit starts. The engine should start. If it does not,
repeat this instruction.
IF THE UNIT WAS RUN FOR 10-15 MINUTES AND THE ENGINE
IS HOT... perform steps 3 - 10 to restart the engine. Continue to
squeeze the throttle control. Run the unit for 2-5 minutes, or as
needed. The unit may be used during this time. Then move
the choke lever to Position 3.
If the engine speed fluctuates in Position 3, squeeze and hold
the throttle control, move the choke lever to Position 2, and run
the unit for 2-5 minutes, or as needed. The unit may be used
during this time. Then move the choke lever to Position 3.
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 9).
USING THE SPEED START™ ACCESSORY
Item No.
316.85951 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Plug-In Power Start
316.85951 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Power Bit Start
316.85953 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Cordless Power Start
12
Description
Speed Start™
Port
Fig. 13