Maintenance; Power Source; Welding Gun And Torch - ESAB Warrior 500i CC/CV Manual De Instrucciones

US
GMAW and self shielded cored wire welding
An arc melts a continuously supplied wire. The weld pool is protected by shielding
gas.
For GMAW and self shielded cored wire welding, the power source shall be supple­
mented with:
S
wire feed unit
S
welding gun
S
connection cable between power source and wire feed unit
S
gas cylinder
S
return cable
6

MAINTENANCE

Regular maintenance is important for safe, reliable operation.
Only personnel with the appropriate electrical skills (authorized staff) may remove
safety plates.
Supplier warranty is void if customer attempts any work on product during the
warranty period.
6.1

Power source

Check regularly that the welding power source is not clogged with dirt.
How often and which cleaning methods apply depend on:
S
the welding process
S
the arc times
S
the placement
S
the surrounding environment
It is normally sufficient to blow down the power source with dry compressed air
(reduced pressure) once a year.
Clogged or blocked air inlets and outlets will otherwise result in overheating.
6.2

Welding gun and torch

A regular programme of care and maintenance reduces unnecessary and expensive
downtime.
Each time a wire bobbin is changed, the welding gun should be removed from the
wire feeder and blown clean with compressed air.
The wire end must not have sharp edges when inserted into the wire liner.
For detailed information see instruction manuals for welding guns and torches.
bu22a
- 17 -
© ESAB AB 2013