Samsung RF24J9960S4 Manual Del Usuario página 34

Removing any residual matter inside the
water supply line after installing the water
fi lter.
1. Turn ON the main water
supply if you turned it
off when you installed
the water fi lter.
2. Run water through the
dispenser until the water
runs clear (approx. 6
to 7 minutes). This will
clean the water supply
system and remove air
from the lines.
3. Additional fl ushing may be required in some
households.
4. Open the Refrigerator door and make sure
there are no water leaks coming from the water
fi lter.
• Be sure to fl ush the dispenser thoroughly,
otherwise water may drip from the
dispenser.
This means that there is still air in the line.
Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.) If
the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment fi lter in the
reverse osmosis system is blocked. Replace
the fi lter if necessary.
• Allow the storage tank on the reverse osmosis
system to refi ll after heavy usage.
• If your refrigerator has a water fi lter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.
DA68-03013A-13.indb 34 DA68-03013A-13.indb 34
All manuals and user guides at all-guides.com
CONTROLLING THE
TEMPERATURE
RECOMMENDED FREEZER AND
REFRIGERATOR COMPARTMENT
TEMPERATURES
The recommended temperatures for the Freezer
and Refrigerator Compartments are 0 °F and 37 °F
(-18 °C and 3 °C) respectively.
If the temperature of the Freezer and Refrigerator
Compartments are too high or low, adjust the
temperature manually.
Controlling the Freezer temperature
Freezer
The Freezer temperature can be set between -8 °F
and 5 °F (or between -23 °C and -15 °C) to suit
your particular needs.
Press the Freezer button repeatedly until the
desired temperature is shown in the temperature
display. The temperature will change by 1 °F (or
1 °C) with each press.
See below.
Fahrenheit : 0 °F ➞ -1 °F ➞ -2 °F ➞ -3 °F ➞ -4 °F
➞ -5 °F ➞ -6 °F ➞ -7 °F ➞ -8 °F ➞ 5 °F ➞ 4 °F ➞
3 °F ➞ 2 °F ➞ 1 °F ➞ 0 °F.
Centigrade : -18 °C ➞ -19 °C ➞ -20 °C ➞ -21 °C
➞ -22 °C ➞ -23 °C ➞ -15 °C ➞ -16 °C ➞ -17 °C
➞ -18 °C.
English - 34
Recommended Temp. : 0 °F (-18 °C) Recommended Temp. : 0 °F (-18 °C)
2015. 8. 26. 2015. 8. 26. 10:30 10:30