Urmet 1760/31 Manual De Instalación página 11

10. Configuration dip-switch (SW1 / SW2):
– no.1 of SW1, if set to ON, it enables the "Simultaneous ignition" parameter which allows the video
door phones in the apartment to switch on at the same time as they receive a call from the calling
station.
The service is available if the video door phones in the apartment:
– have been connected directly to the LINE 1 ÷ 4 input of a video distributor Ref. 1083/55;
– the dip-switch n.1 of SW1 on all the Ref. 1760/31 - /33 video door phones has been set to ON;
– no. 2-8 of SW1, to define the apartment number in the column;
– no. 1-2 of SW2, to define the station number in the apartment.
For DIP-switch settings for user code configuration, refer to the 2Voice system booklet.
Video door phone is provided with an embedded device for hard of hearing.
3. INSTALLATION
• Embed the flush-mounting box Mod. 503 in the wall or the flush-mounting box Ø 60 at the height shown
in the following drawing.
The flush-mounting box Mod. 503 can be installed either horizontally or vertically.
• Fix the bracket to the mounting box as indicated.
• Program the dip-switches and connect the system wires to the terminal boards.
• Move the video door phone close to the bracket by centring the special fixings 1 and slide it down to
reach its stop 2 .
DS1760-009A
SW2 SW1
Box 503
1
O N O N
= =
2
Box Ø 60 mm
11