Fronius MHP 500 S R Manual De Instrucciones página 53

Fitting the welding system to a conventional robot
Safety
Work that is carried out incorrectly can cause serious injury or damage.
▶
▶
An electric shock can be fatal.
Before starting the work described below:
▶
▶
▶
Risk of serious injury and damage from articles being dropped.
For all of the screw connections referred to below:
▶
▶
▶
Fitting the Trans- Individual components must be fitted to the robot in the following order:
Steel welding 1.
system to a con- 2.
ventional robot 3.
4.
5.
6.
WARNING!
The following activities may only be carried out by trained and qualified personnel.
The Operating Instructions for system components, particularly the chapter entitled
"Safety rules", must be observed.
WARNING!
Turn the power source mains switch to the "O" position
Disconnect the power source from the mains
Ensure that the power source remains disconnected from the mains until all work
has been completed.
WARNING!
Check after fitting to ensure they are tight
Check following an unusual operating situation (e.g. crash) to ensure they are tight
Check regularly to ensure they are tight
Wirefeeder - the wirefeeder holder and the side arm holder must be fitted first
CrashBox /i
Clamp system
Torch hosepack
Robot welding torch
Interconnecting hosepack
53