Publicidad
• 0
IDENTIFICATION
Identify your type of hob by comparing
the number and layout
on your appliance with the illustrations
• 1
INSTALLATION
Make a note of the references of your
appliance on the "After-Sales Service
and Customer Relations" page so that
you can readily find them in future
(6.1.1). This page also explains where to
find them on your appliance.
1•1 - FITTING :
This worktop must be at least 3 cm thick
and heatresistant or else coated with a
heat resistant material.
If a horizontal partition is installed under
the hob, it must be positioned 15 cm
below the worktop. (1.1.2).
If the hob is going to be installed on
the top of an oven, precautions must
be taken to guarantee an installation
in accordance with current accident
prevention standards.
Under no circumstances keep any
sprays or pressurised containers in any
compartment below the hob (see "Safety
guidelines" chapter).
Follow the guidelines in the sketch.
(1.1.1).
• Remove the "pan supports", burner
caps and burner heads, noting their
original positions.
• Turn the hob upside down and place
it carefully over the top of the base
unit, so as not to damage the knobs or
igniters.
• To ensure a good seal between the
body of the hob and the worktop, stick
the foam seal around the edge
of the burners
S
(0.1.1) and (0.1.2).
of the body, before installing the hob
(1.1.5).
• Place the hob over the opening in the
base unit, taking care to center the hob.
• Fit the burner heads, caps and pan
supports.
• Connect your hob to the gas (see
"Gas connection" section) and to the
electricity (see "Electrical connection"
section).
• If you wish, you can secure the hob
in position, using the four fixing clam
and screws supplied supplied
C
(1.1.3/1.1.4) fixing them to the four
corners of the housing. It is essential
that you use the holes provided for the
purpose, as per the drawing.
Stop screwing when the clamp starts
to bend.
Do not use a power screwdriver.
• Installation
is not equipped with a device for the
evacuation of combustion products,
so it is necessary to evacuate the
fumes outwards using a hood or an
electric fan inserted to walk every time
the device is used. The room in which
the appliance is installed must have
a natural inflow of air for the regular
combustion of the gas and for the
ventilation of the room.
7
room: This appliance
Publicidad
