▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 26
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a hand-held cordless drill/driver.
It is designed for
•
Predrilling in steel and aluminum
•
Removing paint and protective coatings
•
Driving SBT screw-in studs to the correct depth
•
Tightening nuts
•
Drilling in metal, wood, plastic
•
Driving and removing screws
•
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
•
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3
ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
20
English
1
Keyless chuck
@
Torque, drilling and BT mode selector ring
;
Auxiliary handle
=
Gear selector switch
%
Forward/reverse switch with transport lock
&
Control switch with electronic speed control
(
Grip
)
Work-area light (LED)
+
Installation opening for accessories
§
Battery
/
Release button, battery
:
Battery status indicator
∙
2368265
*2368265*