Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
No coating material at the
nozzle exit
Coating material to the
nozzle by dropwise
To coarse atomization
Pulsating spray jet
Coating material-runner
Too much fog coating
material
Warranty Statement
Without prejudice to the statutory warranty claims, the manufacturer grants a warranty
in accordance with the laws of your
country, but at least 1 year (in Germany 2 years). Warranty start date is the sale of the
unit to the end user.
The warranty covers only those defects which are caused by material or manufactur-
ing defects.
Warranty repairs must be performed by an authorized service center. To make your
claim under warranty must be
accompanied (with date of sale) of the original sales receipt.
Excluded from the warranty are:
- Normal wear and tear
- Improper applications, such as overloading of the device, not approved accessories
- Damage caused by external influences, use of force or by foreign bodies
- Damage caused by not following the instructions, eg connection to the wrong mains
voltage or non-observance of the
installation instructions
- Fully or partially disassembled equipment
Cause
D PTS clogged
Clogged riser
Small holes on the riser pipe clogged.
Amounts of material adjustment screw is turned
too far to the left (-).
Air flow and pressure adjustment knob is turned
too far to the left (counterclockwise)
Riser loose
No pressure build-up in the container.
Nozzle loose
Worn nozzle
Coating material buildup on air cap and nozzle.
Coatings has gsstoff to high viscosity.
Large amount of material to
Amounts of material adjustment screw is turned
too far to the right (+).
Air flow and pressure adjustment knob is turned
too far to the left (counterclockwise).
Contaminated nozzle
Extremely dirty air filter
Too little pressure buildup in the tank
Coating material in the tank is low.
Small holes on the riser pipe clogged.
Air filter is very dirty.
Too much coating material applied
Distance to the object being sprayed too big.
Too much coating material order.
12
Remedy
Clean
Clean
Clean
To the right (+)
To the left (counterclockwise)
To the right (clockwise)
Nstecken egg
Tighten container
Attract
Replace
Clean
Dilute
Amounts of material adjustment
screw to the left (-).
Turn to the left (-)
Knob to the right (clockwise)
Clean
Replace
Tighten container
Top up
Clean
Replace
Check material quantity
Reduce spray distance
Publicidad
